Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Connecting the output of a heating element with surface temperature
Posted Mar 10, 2017, 6:05 a.m. EST Heat Transfer & Phase Change Version 5.2a 2 Replies
Please login with a confirmed email address before reporting spam
Dear All,
Momentarily I'm working on a wall set up with an active wall heating system.
Now is the goal that the inside surface temperature of stays stable.
It can be seen as a heating element in the wall which output in Watt, is regulated by a sensor on the wall surface.
How can I model this in the program and is that even possible?
Besides, the Output of the heating system will vary, due to changing condition, therefore if it is possible is there a way to determine the output of the heating element in the wall in time?
Thanks on beforehand.
With kind regards,
Glenn Pennings
Momentarily I'm working on a wall set up with an active wall heating system.
Now is the goal that the inside surface temperature of stays stable.
It can be seen as a heating element in the wall which output in Watt, is regulated by a sensor on the wall surface.
How can I model this in the program and is that even possible?
Besides, the Output of the heating system will vary, due to changing condition, therefore if it is possible is there a way to determine the output of the heating element in the wall in time?
Thanks on beforehand.
With kind regards,
Glenn Pennings
2 Replies Last Post Mar 10, 2017, 1:52 p.m. EST
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Dear Glenn,
It sounds as if you're describing a thermostat. If that is the case you may find these articles helpful:
www.comsol.com/blogs/implementing-a-thermostat-with-the-events-interface/
www.comsol.com/blogs/how-to-implement-a-delay-in-your-thermostat-simulation/
Best Regards,
It sounds as if you're describing a thermostat. If that is the case you may find these articles helpful:
www.comsol.com/blogs/implementing-a-thermostat-with-the-events-interface/
www.comsol.com/blogs/how-to-implement-a-delay-in-your-thermostat-simulation/
Best Regards,
Please login with a confirmed email address before reporting spam
Posted:
7 years ago
Thank you very much for the reply.
I will take a look at it.
With kind regards,
Glenn Pennings
I will take a look at it.
With kind regards,
Glenn Pennings