Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

muti-turn coil

Please login with a confirmed email address before reporting spam

(http://)(http://)The below post is related to an archived discussion


how to find the automatic current calculation ? I have set the coil type to the numeric and set the next to the circual current,But I cannot find the automatic current calculation under the multi-turn coil.


1 Reply Last Post Sep 20, 2017, 3:29 p.m. EDT
Nirmal Paudel Tribhuvan University/Electrical Engineering

Please login with a confirmed email address before reporting spam

Posted: 7 years ago Sep 20, 2017, 3:29 p.m. EDT
Updated: 7 years ago Sep 20, 2017, 3:29 p.m. EDT

Hi There,

Please follow either of these two models to understand the correct setup for homogenized multi-turn coil in COMSOL. https://www.comsol.com/model/multi-turn-coil-winding-around-a-ferromagnet-23641

https://www.comsol.com/model/multi-turn-coil-above-an-asymmetric-conductor-plate-13777

Best Regards,

Nirmal

Hi There, Please follow either of these two models to understand the correct setup for homogenized multi-turn coil in COMSOL. https://www.comsol.com/model/multi-turn-coil-winding-around-a-ferromagnet-23641 https://www.comsol.com/model/multi-turn-coil-above-an-asymmetric-conductor-plate-13777 Best Regards, Nirmal

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.