Meshing 2D Material

Please login with a confirmed email address before reporting spam

Hello!

I am new at using COMSOL Multiphysics, and I am currently learning how to use it in order to simulate the heat flux across a 2D Material that is deposited between a heater bar and a sensor bar. I am currently struggling to mesh the model because the aspect ratio of the thin film is so high (I made my thin film as a block of dimensions 0.2um, 10um, and 6A). I was wondering if there was a way to possibly maybe make seperate meshes for the rest of the model and the deposited material, or if there was another work around for this issue.

Thank you, Annalies Tipton


0 Replies Last Post 5 Aug 2020, 22:57 GMT-4
COMSOL Moderator

Hello Annalies Tipton

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.