# Discussion Forum

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

## Modelling Compression of Material at a Rate

Hello,

I am a beginner to COMSOL 4.2a and I would like to build a simple model where a material (a cylindrical block of polymer) is compressed at a rate of 10 mm/min.

Using Solid Mechanics, I was able to construct the cylinder and apply a boundary load. However, this is just an instantaneous load.

My question is how do I go about implementing a compression of the material at a rate of 10mm/min?

5 Replies Last Post 18 Jan 2013 10:17 GMT-05:00
Posted: 5 years ago
Hi

you can work in th time domain, and say the displacement is 10[mm/s]*t, but try to smoothen the displacement velocity as you will get many transient at the beginning around t=0, one way to improve is to remove the inertial terms (2nd order derivatives) but then you remove all wave propagations. But you can also, if the time behaviour is not the essential use a stationary parametric sweep and increase either the force load with a parameter or impose a displacement with a parameter. You loose the time response but you see the displacement force response, interesting in particular if your material is nonlinear, or for large deformations

--
Good luck
Ivar

Posted: 5 years ago

Hi

you can work in th time domain, and say the displacement is 10[mm/s]*t, but try to smoothen the displacement velocity as you will get many transient at the beginning around t=0, one way to improve is to remove the inertial terms (2nd order derivatives) but then you remove all wave propagations. But you can also, if the time behaviour is not the essential use a stationary parametric sweep and increase either the force load with a parameter or impose a displacement with a parameter. You loose the time response but you see the displacement force response, interesting in particular if your material is nonlinear, or for large deformations

--
Good luck
Ivar

Thank you Ivar. I will try your suggestions and see where I can get.

Thanks,

Posted: 5 years ago
Update:

I tried to apply a prescribed velocity and conducted a time-dependent study. However, I am getting a

"Failed to find a solution" error message.

It says that there are void equations (empty rows in matrix) and returned solution is not converged.

Looking up previous discussions, it seems that this error could be tied to the size of the mesh. However, I have tried different mesh sizes with no avail.

Any suggestions would be great!

Thanks!

Posted: 5 years ago
Hi

are you using a segregated iterative solver or a direct one, perhaps the direct one would work (if you have enough RAM)

--
Good luck
Ivar

Posted: 5 years ago