Hinge model

Please login with a confirmed email address before reporting spam

Hi all,

I've modelled a hinge with structural mechanics module via a rigid connector. Can anyone tell me how I can move (rotate) the connected solid object along the axis of the pin hole?? I've attached the model file and a photo for better understanding.

Many thanks

Shaghayegh



3 Replies Last Post 1 Jul 2019, 15:16 WEST
Pawan Soami COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 months ago 21 Jun 2019, 05:50 WEST
Updated: 4 months ago 21 Jun 2019, 05:50 WEST

Dear Shaghyegh,

It seems you are using Form union in the geometry whereas for multibody modeling, in order to allow relative motion between the two components, geometry should use Form assembly. Note that before using Form assembly you need to use one or several Union nodes in geometry for domains of each component if they are not already in union state.

You can also refer hinge_assembly model from Application Library for more details.

Best regards, Pawan Soami

Dear Shaghyegh, It seems you are using Form union in the geometry whereas for multibody modeling, in order to allow relative motion between the two components, geometry should use Form assembly. Note that before using Form assembly you need to use one or several Union nodes in geometry for domains of each component if they are not already in union state. You can also refer hinge_assembly model from Application Library for more details. Best regards, Pawan Soami

Please login with a confirmed email address before reporting spam

Posted: 4 months ago 21 Jun 2019, 09:50 WEST

Dear Pawan,

Thank you very much for your help.

Kind regards, Shaghayegh

Dear Pawan, Thank you very much for your help. Kind regards, Shaghayegh

Please login with a confirmed email address before reporting spam

Posted: 4 months ago 1 Jul 2019, 15:16 WEST

Dear Pawan, I tried using Form assembly and before that I had grouped the domains by using Form union. However, I receieved error. It seems that there is an issue with the way of applying the load and the amount of it. Could you please help me,

Best regards, Shaghayegh

Dear Pawan, I tried using Form assembly and before that I had grouped the domains by using Form union. However, I receieved error. It seems that there is an issue with the way of applying the load and the amount of it. Could you please help me, Best regards, Shaghayegh

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.