Menu

Discussion Forum

New Discussion
Filter

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

meshing in 3D- quad mapped mesh

Posted May 16, 2011, 4:32 a.m. EDT 0 Replies

Linda Boatemaa
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello Everyone,

I am working on two cylinders, one smaller one in a bigger one (same height but different radius), I normally use a tringular boundary mesh then sweep it downwards and it was ok,

but i have to increase height maintaining the same radius for both cylinders, and if i increase the height the same mesh doesnt work, the radius is 1µm and 100µm with a height of 400µm,

I need to create a mapped quad for the boundary face, and i cant seem to figure that out..........

thanks in advance for any help
LINDA!
0 Replies Last Post May 16, 2011, 4:32 a.m. EDT
COMSOL Moderator

Hello Linda Boatemaa

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content