Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to convert 3D sweep geometry in 2D
Posted Oct 31, 2019, 2:37 p.m. EDT Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics Version 5.3a 2 Replies
Please login with a confirmed email address before reporting spam
Hello everyone, Could you please tell me how can I convert 3D sweep geomtery into 2D or 2D axissymetric? I want to make tortuous uniform diameter pipe in 2D. I want to change my tortuosity each time and diamter have to be remain same. Thank you.
Attachments:
Please login with a confirmed email address before reporting spam
Hi,
I was quite surprised that the sweep function is not available in 2D. I think I had come across the issue earlier when I found I couldn't for some reasons sweep edges in 3D. Well I found some workaround then.
I am attaching a modified model showing how to obtain a cross section from the 3D component and refer to it in a 2D component. Key is to set up the appropriate work plane that defines the cross section in the 3D component.
This procedure looks a little overengineered and may be, I hope even, there is a simpler method. If not I hope this one works for you.
Cheers Edgar
-------------------Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Attachments:
Please login with a confirmed email address before reporting spam
Thank you very much. Right now i am working on 5.3a version, therefore i couldnot able to open the file. Could you please convert this file as 5.3 version. I really appreciate your help. Thank you.