Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Surface to surface radiation between plates

Shikha Ebrahim
Hello,

I have problem regarding surface to surface radiation while modelling a channel with air flow into the channel.

The lower plate of the channel has surface emissivity of 0.02 and the upper plate has surface emissivity of 0.9. The upper plate is heated by a constant heat flux.

So, How can I specify this in COMSOL.

Is it enough to chose surface to surface radiation ? When should i use opacity surface ?

Thank you n advanced

0 Replies Last Post 26 Jun 2013 16:09 GMT-04:00
COMSOL Moderator

Hello Shikha Ebrahim

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.