Menu

Discussion Forum

New Discussion
Filter

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Question for the inductor_3d model in the AC/DC module

Posted Mar 16, 2015, 12:13 p.m. EDT Low-Frequency Electromagnetics Version 4.4 0 Replies

Ming Sun
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

After reading the "Introduction to AC/DC module" pdf file (for Rev 4.4), I noticed in the Fig 8 and 9, the lumped port impedance has the capacitance and it makes the resonant with the inductor. But going through the whole paper, I am not able to see in which step, the setup is performed for the capacitance modelling or calculation.

I assume to get the parasitic capacitance value, the ELECTROSTATICS is needed to be involved. But it is not mentioned in the paper.

I may miss something and please advise.

Thanks,
Ming
0 Replies Last Post Mar 16, 2015, 12:13 p.m. EDT
COMSOL Moderator

Hello Ming Sun

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content